[afnog] Cisco 7204 VXR crashing and goes into reboot loop
Oluwaseun Ojedeji
seun.ojedeji at gmail.com
Wed Jun 9 15:43:19 UTC 2010
Dear Shepherd,
Does it also reboot without being connected to the LAN? could you try an
ios-upgrade? (or the reboot time will not permit?)
Regards
On Wed, Jun 9, 2010 at 4:01 PM, Shepherd Magumo <shepherd at snowball.co.za>wrote:
> Good day,
>
> Cisco router is crashing and restarting within a few minutes of powering
> up. I managed to assign an IP address last night and left it running only to
> discover it was in a reboot loop.
>
> Part of the error that I am getting is as shown below:
>
>
> %ERR-1-GT64120 (PCI-0): Fatal error, Memory parity error
> (external)sages
> (0x40):arb/serr, chip ctrl = 0x02000000rivate Dial
> GT=0xB5000000, cause=0x0100E283, mask=0x0ED01F00,
> real_cause=0x00000200vpdn-group VPDN grou
> (0x68):sec clk ctrl,serrsta = 0x00
> bus_err_high=0x00000000, bus_err_low=0x00000000,idge 2, for PA bay 2,
> 4
>
> System bridge dump:
> Rout
> (
>
> Bridge 0, for PCMCIA and IO-FE, Handle=0otocol interf
> Router(config)#
> (0
> DEC21150 bridge chip, config=0x0F0A00uter(config)#
> sdr
> (0x00):dev, vendor id = 0x00231011 = 0x02A0F1A1mands
> Router(config)#
> (0x04):status, command = 0x02B00147 = 0x4FF04D00nfig)# DDN IP
> Route
> (0x08):class code, revid = 0x06040006 = 0x0001FF01 spli
> 00:39:36: %SYS-5-CON
> (0x0C):hdr, lat timer, cls = 0x00012E10 = 0x00200020
> summary-address
> (0x18):sec lat,cls & bus no = 0x18020100 = 0x00030000e per line. End with
> CNTL/
> (0x1C):sec status, io base = 0x02A03101 = 0x02000000rs
> Router(config)#?
> (0x20):mem base & limit = 0x48704000 = 0xF0
>
> Router(confi
> (0x20):mem base & limit = 0x4AF04880N global configuration commands#int
> f1/0
> (0x24):prefetch membase/lim = 0x0001FF01#ip adr
> buffers
> (0x30):io base/lim upper16 = 0x00000000souter(config-if)#ip address dh
> (0x3C):bridge ctrl = 0x00030000 Configure Call
> paramete
> (0x40):arb/serr, chip ctrl = 0x02000000p
> call-histo
> DEC21150 b
> (0x64):serr disable, gpio = 0xF0000000
> (0x00):dev, vendor id
> (0x68):sec clk ctrl,serrsta = 0x000001FF
> (0x04):status, command
>
> Bridge 2, for PA bay 2, 4 and 6, Handle=2
> (0x08):class code, revid =
> DEC21150 bridge chip, config=0x0odem chat script68
> (0x0C):hdr, l
> (0x00):dev, vendor id = 0x00231011 class-map
> (0x18):sec la
> (0x04):status, command = 0x02B00147 ^
>
> (0x1C):sec st
> (0x08):class code, revid = 0x0
> (0x68):sec clk ctrl,serrsta = 0x000001FFal Cont
>
> *** System received an Error In
>
> PA bridge dump:o service passw
>
> Bridge 4, Port Adaptor 1, Handle=1code= 0x0, context= 0x608b2cf8nfig
>
> Invalid bridge chip, vendor/id=0xFFFFFFFF = 0x60362a38, Cause =
> 0x6420, Sta
>
>
> === Flushing messages () ===
> !
> interface Fas
> Copyright
>
> *** System received an Error Interrupt ***lobal configuration commands
> duplex
> C72
> signal= 0x16, code= 0x0, context= 0x608b2cf8
> dnsix-dmdp
> PC = 0x60362a38, Cause = 0x20, Status Reg = 0x34008002e is not
> initializedo ip address
> dnsix-nat
>
> System Bootstrap, Version 12.1(20000824:081033)
> [dbeazley-cosmos_e_LATEST 101],0
>
> Router#sh
> Router#show in
> d
> trouble reading device magic n
> DEVELOPMENT SOFTWAREcompatible with old
>
> Copyright (c) 1994-2000 by cisco Systems, Inc.
> boot: cannot determine first file name o
> C7200 platform with 262144 Kbytes of main memoryc)
> dspint
>
> System Bootstrap, Ver
>
>
> Read cis from dev 0 error (-6)PCMCIA slot0 device is not initialized
>
>
>
> Restricted Rights Legendd Computer Enable voip gateway a
>
> Use, duplication, or disclosure by the Government is sec.
> 252.227-7013. help Desc
> subject to restrictions as set forth in subparagraph
> 18 output e
> 170 West Tasman Drive
> (c) of the Commercial Computer Software - Restricted California
> 95134-1706s, 0 late collision, 0 deferre
> Rights clause at FAR sec. 52.227-19 and subparagraphoftwaree to
> configurearrier
>
> (c) (1) (ii) of the Rights in Technical Data and ComputerEARLY
> DEPLOYMENT RELEAation subcommands
> Router#show ru
> Software clause at DFARS sec. 252.227-7013.
> SE SOFTWARE (fc1)
>
> Cisco Internetwork Operating System Software
>
>
> %ERR-1-GT64120 (PCI-0): Fatal er
> IOS (tm) 7200 Software (C7200-BOOT-M), Version 12.0(13)S, EARLY
> DEPLOYMENT RELEA
> line
> GT=0xB5000000, cause=0x0100E283, mask=0x0ED01F00, real_ca
> SE SOFTWARE (fc1)s
> Copyright (c) 1986-2000 by cisco Systems, Inc.anag
> bus_err_high=0x00000000, bus_err_low=0x0
> Compiled Fri 29-Sep-00 17:46 by pwadetablish queueing priorities based on
> Image text-base: 0x60008948, data-base: 0x606AA000PCI bus
> system/parity error
> location
>
>
> %ERR-1-GT64120 (PCI-0): Fatal error, Memory parity error (external)
> !
> interface FastEthernet1/0
> err_stat=0x81, err_enable
> GT=0xB5000000, cause=0x0100E283, mask=0x0ED01F00, real_cau ATM3/0
>
> System bridge dump:address
>
>
> call r
> (0x20):mem base & limit = 0x48704000!
>
> network-clock-select Networ
> (0x24):prefetch membase/lim = 0x0001FF01=1
> shutdown
> no
> (0x30):io base/lim upper16 = 0x00000000 defaults
> ip a
> (0x00):dev,
> (0x3C):bridge ctrl = 0x00030000 Co
> (0x04):statu
> (0x40):arb/serr, chip ctrl = 0x02000000
> num-exp
> (0x08):class
> (0x64):serr disable, gpio = 0xF0000000http server
> (0x0C):hdr,
> (0x68):sec clk ctrl,serrsta = 0x000001FFrser C
> (0x18):sec l
>
> Bridge 1, for PA bay 1, 3 and 5, Handle=1
>
> policy-map
> (0x1C):sec stat
> DEC21150 bridge chip, config=0x0rfaces f1/0
> (0x00):dev, vendor id = 0x00231011ild a priority list
> (0x04):status, command = 0x02B00147e Command
> privilege pa
> (0x08):class code, revid = 0x0
> (0x04):status, command = 0x02B00147 RTR Base
> Configuration
> (0x08):class code, revid = 0x06040006s, 0 runts,
> sap-priority-list
> (0x0C):hdr, lat timer, cls = 0x00012E10SAP and/or
> 0 input errors, 0 CRC
> (0x18):sec lat,cls & bus no = 0x180F0A00
> M
> (0x1C):sec status, io base = 0x02A0F1A1 0 input packets
> scheduler
> (0x20):mem base & limit = 0x4FF04D004, Port Adaptor 1, Handle=1170
> packets
>
> (0x24):prefetch membase/lim = 0x0001FF01p, config=0x0ed services
> (0x30):io base/lim upper16 = 0x0020002031011ons,
> sgbp
> (0x3C):bridge ctrl = 0x0003000000147n 0 babbles, 0 late
> collision, 0 d
> (0x40):arb/serr, chip ctrl = 0x0200000040006sgcp
> Enable
> (0x64):serr disable, gpio = 0xF000000011A10 output buffer failures, 0
> output b
> (0x68):sec clk ctrl,serrstbus
> Invalid bridge chip, vendor/id=0xFFFFFFFF User Agent (UA)D
> (0x24):prefetch membase
>
> Let me know what I can check here. Thanks in advance for your help.
>
> regards,
>
> Shepherd
>
> _______________________________________________
> afnog mailing list
> http://afnog.org/mailman/listinfo/afnog
>
--
------------------------------------------------------------------------
Seun Ojedeji,
System Analyst/Network Admin
ICT Centre,
University of Nigeria, Enugu Campus.
web: http://www.unn.edu.ng
Mobile: +2348035233535
Email: seun.ojedeji at unn.edu.ng
seun.ojedeji at gmail.com
-------------- next part --------------
An HTML attachment was scrubbed...
URL: <http://afnog.org/pipermail/afnog/attachments/20100609/e5c6bf69/attachment.htm>
More information about the afnog
mailing list