[afnog] Cisco 7204 VXR crashing and goes into reboot loop

Wed Jun 9 15:51:23 UTC 2010

Oluwaseun,

It is rebooting even when it is not connected to the LAN. I even removed the
ATM and FastEth modules and still the router reboots. The reboots do not
allow any IOS upgrades to happen.

What else can I possibly try?

regards,

Shepherd

On Wed, Jun 9, 2010 at 5:43 PM, Oluwaseun Ojedeji <seun.ojedeji at gmail.com>wrote:

> Dear Shepherd,
> Does it also reboot without being connected to the LAN? could you try an
> ios-upgrade? (or the reboot time will not permit?)
>
> Regards
> On Wed, Jun 9, 2010 at 4:01 PM, Shepherd Magumo <shepherd at snowball.co.za>wrote:
>
>> Good day,
>>
>> Cisco router is crashing and restarting within a few minutes of powering
>> up. I managed to assign an IP address last night and left it running only to
>> discover it was in a reboot loop.
>>
>> Part of the error that I am getting is as shown below:
>>
>>
>> %ERR-1-GT64120 (PCI-0): Fatal error, Memory parity error
>> (external)sages
>> (0x40):arb/serr, chip ctrl  = 0x02000000rivate Dial
>>  GT=0xB5000000, cause=0x0100E283, mask=0x0ED01F00,
>> real_cause=0x00000200vpdn-group                  VPDN grou
>> (0x68):sec clk ctrl,serrsta = 0x00
>>  bus_err_high=0x00000000, bus_err_low=0x00000000,idge 2, for PA bay 2,
>> 4
>>
>> System bridge dump:
>> Rout
>> (
>>
>> Bridge 0, for PCMCIA and IO-FE, Handle=0otocol interf
>> Router(config)#
>> (0
>> DEC21150 bridge chip, config=0x0F0A00uter(config)#
>>  sdr
>> (0x00):dev, vendor id       = 0x00231011 = 0x02A0F1A1mands
>> Router(config)#
>> (0x04):status, command      = 0x02B00147 = 0x4FF04D00nfig)#        DDN IP
>> Route
>> (0x08):class code, revid    = 0x06040006 = 0x0001FF01  spli
>> 00:39:36: %SYS-5-CON
>> (0x0C):hdr, lat timer, cls  = 0x00012E10 = 0x00200020
>>  summary-address
>> (0x18):sec lat,cls & bus no = 0x18020100 = 0x00030000e per line.  End with
>> CNTL/
>> (0x1C):sec status, io base  = 0x02A03101 = 0x02000000rs
>> Router(config)#?
>> (0x20):mem base & limit     = 0x48704000 = 0xF0
>>
>> Router(confi
>> (0x20):mem base & limit     = 0x4AF04880N global configuration
>> commands#int f1/0
>> (0x24):prefetch membase/lim = 0x0001FF01#ip adr
>>  buffers
>> (0x30):io base/lim upper16  = 0x00000000souter(config-if)#ip address dh
>> (0x3C):bridge ctrl          = 0x00030000                 Configure Call
>> paramete
>> (0x40):arb/serr, chip ctrl  = 0x02000000p
>>  call-histo
>> DEC21150 b
>> (0x64):serr disable, gpio   = 0xF0000000
>> (0x00):dev, vendor id
>> (0x68):sec clk ctrl,serrsta = 0x000001FF
>> (0x04):status, command
>>
>> Bridge 2, for PA bay 2, 4 and 6, Handle=2
>> (0x08):class code, revid    =
>> DEC21150 bridge chip, config=0x0odem chat script68
>> (0x0C):hdr, l
>> (0x00):dev, vendor id       = 0x00231011  class-map
>> (0x18):sec la
>> (0x04):status, command      = 0x02B00147            ^
>>
>> (0x1C):sec st
>> (0x08):class code, revid    = 0x0
>> (0x68):sec clk ctrl,serrsta = 0x000001FFal Cont
>>
>> *** System received an Error In
>>
>> PA bridge dump:o service passw
>>
>> Bridge 4, Port Adaptor 1, Handle=1code= 0x0, context= 0x608b2cf8nfig
>>
>> Invalid bridge chip, vendor/id=0xFFFFFFFF = 0x60362a38, Cause =
>> 0x6420, Sta
>>
>>
>> === Flushing messages () ===
>> !
>> interface Fas
>> Copyright
>>
>> *** System received an Error Interrupt ***lobal configuration commands
>>  duplex
>> C72
>> signal= 0x16, code= 0x0, context= 0x608b2cf8
>>  dnsix-dmdp
>> PC = 0x60362a38, Cause = 0x20, Status Reg = 0x34008002e is not
>> initializedo ip address
>>  dnsix-nat
>>
>> System Bootstrap, Version 12.1(20000824:081033)
>> [dbeazley-cosmos_e_LATEST 101],0
>>
>> Router#sh
>> Router#show in
>>  d
>> trouble reading device magic n
>> DEVELOPMENT SOFTWAREcompatible with old
>>
>> Copyright (c) 1994-2000 by cisco Systems, Inc.
>> boot: cannot determine first file name o
>> C7200 platform with 262144 Kbytes of main memoryc)
>>  dspint
>>
>> System Bootstrap, Ver
>>
>>
>> Read cis from dev 0 error (-6)PCMCIA slot0 device is not initialized
>>
>>
>>
>>              Restricted Rights Legendd Computer       Enable voip gateway
>> a
>>
>> Use, duplication, or disclosure by the Government is sec.
>> 252.227-7013. help                        Desc
>> subject to restrictions as set forth in subparagraph
>>     18 output e
>>           170 West Tasman Drive
>> (c) of the Commercial Computer Software - Restricted California
>> 95134-1706s, 0 late collision, 0 deferre
>> Rights clause at FAR sec. 52.227-19 and subparagraphoftwaree to
>> configurearrier
>>
>> (c) (1) (ii) of the Rights in Technical Data and ComputerEARLY
>> DEPLOYMENT RELEAation subcommands
>> Router#show ru
>> Software clause at DFARS sec. 252.227-7013.
>> SE SOFTWARE (fc1)
>>
>> Cisco Internetwork Operating System Software
>>
>>
>> %ERR-1-GT64120 (PCI-0): Fatal er
>> IOS (tm) 7200 Software (C7200-BOOT-M), Version 12.0(13)S, EARLY
>> DEPLOYMENT RELEA
>>  line
>>  GT=0xB5000000, cause=0x0100E283, mask=0x0ED01F00, real_ca
>> SE SOFTWARE (fc1)s
>> Copyright (c) 1986-2000 by cisco Systems, Inc.anag
>>  bus_err_high=0x00000000, bus_err_low=0x0
>> Compiled Fri 29-Sep-00 17:46 by pwadetablish queueing priorities based on
>> Image text-base: 0x60008948, data-base: 0x606AA000PCI bus
>> system/parity error
>>  location
>>
>>
>> %ERR-1-GT64120 (PCI-0): Fatal error, Memory parity error (external)
>> !
>> interface FastEthernet1/0
>>  err_stat=0x81, err_enable
>>  GT=0xB5000000, cause=0x0100E283, mask=0x0ED01F00, real_cau ATM3/0
>>
>> System bridge dump:address
>>
>>
>> call r
>> (0x20):mem base & limit     = 0x48704000!
>>
>>  network-clock-select        Networ
>> (0x24):prefetch membase/lim = 0x0001FF01=1
>>  shutdown
>>  no
>> (0x30):io base/lim upper16  = 0x00000000 defaults
>>  ip a
>> (0x00):dev,
>> (0x3C):bridge ctrl          = 0x00030000                         Co
>> (0x04):statu
>> (0x40):arb/serr, chip ctrl  = 0x02000000
>>  num-exp
>> (0x08):class
>> (0x64):serr disable, gpio   = 0xF0000000http server
>> (0x0C):hdr,
>> (0x68):sec clk ctrl,serrsta = 0x000001FFrser                      C
>> (0x18):sec l
>>
>> Bridge 1, for PA bay 1, 3 and 5, Handle=1
>>
>>  policy-map
>> (0x1C):sec stat
>> DEC21150 bridge chip, config=0x0rfaces f1/0
>> (0x00):dev, vendor id       = 0x00231011ild a priority list
>> (0x04):status, command      = 0x02B00147e                   Command
>> privilege pa
>> (0x08):class code, revid    = 0x0
>> (0x04):status, command      = 0x02B00147                  RTR Base
>> Configuration
>> (0x08):class code, revid    = 0x06040006s, 0 runts,
>>  sap-priority-list
>> (0x0C):hdr, lat timer, cls  = 0x00012E10SAP and/or
>>     0 input errors, 0 CRC
>> (0x18):sec lat,cls & bus no = 0x180F0A00
>>                              M
>> (0x1C):sec status, io base  = 0x02A0F1A1   0 input packets
>>  scheduler
>> (0x20):mem base & limit     = 0x4FF04D004, Port Adaptor 1, Handle=1170
>> packets
>>
>> (0x24):prefetch membase/lim = 0x0001FF01p, config=0x0ed services
>> (0x30):io base/lim upper16  = 0x0020002031011ons,
>>  sgbp
>> (0x3C):bridge ctrl          = 0x0003000000147n  0 babbles, 0 late
>> collision, 0 d
>> (0x40):arb/serr, chip ctrl  = 0x0200000040006sgcp
>> Enable
>> (0x64):serr disable, gpio   = 0xF000000011A10 output buffer failures, 0
>> output b
>> (0x68):sec clk ctrl,serrstbus
>> Invalid bridge chip, vendor/id=0xFFFFFFFF User Agent (UA)D
>> (0x24):prefetch membase
>>
>> Let me know what I can check here. Thanks in advance for your help.
>>
>> regards,
>>
>> Shepherd
>>
>> _______________________________________________
>> afnog mailing list
>> http://afnog.org/mailman/listinfo/afnog
>>
>
>
>
> --
> ------------------------------------------------------------------------
> Seun Ojedeji,
> System Analyst/Network Admin
> ICT Centre,
> University of Nigeria, Enugu Campus.
> web:      http://www.unn.edu.ng
> Mobile: +2348035233535
> Email:   seun.ojedeji at unn.edu.ng
>            seun.ojedeji at gmail.com
>
>
-------------- next part --------------
An HTML attachment was scrubbed...
URL: <http://afnog.org/pipermail/afnog/attachments/20100609/c777cc14/attachment-0001.htm>