[afnog] vlans on cisco 2611XM

[Tizhe Bitrus Zira]

HI man, below is the out put of my configuration on my Cisco 2620XM

JOS_router>ena
JOS_router#conf t
Enter configuration commands, one per line.  End with CNTL/Z.
JOS_router(config)#int fa0/0
JOS_router(config-if)#no shut
JOS_router(config-if)#exit
JOS_router(config)#int fa0/0.1
JOS_router(config-subif)#encapsulation dot1q 1
JOS_router(config-subif)#ip add 192.168.1 255.255.255.0
JOS_router(config-subif)#


and it works just fine...







> hi,
>
> i need your help, I'm trying to enable intervlan routing on a cisco 2620
> using IOS 12.2(5d)
>
> when i create subinterfaces on a FastEthernet int and
> try to enable dot1q encapsulation i get the following:
>
> **********************
> Router(config-subif)#encapsulation dot1q 1
> ^
> % Invalid input detected at '^' marker.
>
> Router(config-subif)#encap?
> % Unrecognized command
> **********************
>
> it seems 802.1Q is not supported on the Cisco 2611XM FastEthernet
> interface. is there an other way to use vlans on cisco 2611XM ?
>
> Augustin KANYIMBU M.
> GSM:+243 998 124376
> e-mail: augustin.kanyimbu at unikin.cd
>
>
>
>
> _______________________________________________
> afnog mailing list
> http://afnog.org/mailman/listinfo/afnog
>


++++++++++++++++++++++++++++++++++++++++++++++++++
Tizhe Bitrus Zira CCNA, CCAI
Network Technician
UJNet Department
University of Jos
Jos- Nigeria
Phone:2348036125887
E-mail:bitrust at unijos.edu.ng, tjaybit at yahoo.com, tjaybit at gmail.com
+++++++++++++++++++++++++++++++++++++++++++++++++