[afnog] Failover problem!

[Mohamed Lemine Ould Mohamed Vadel]

Hello,
Thank you for the answer detailed. But how could I upgrade the memory?
Regards.
----------------------------------------
Mohamed Lemine Ould Mohamed Fadel
Chef Centre Internet/ADSL
Tel: +222 525 32 43
Mob: +222 658 63 27
Fax: +222 525 73 58
Mauritel - Mauritanie
----------------------------------------
----- Original Message ----- 
From: "A.I.Fabian" <fabian at udsm.ac.tz>
To: "Mohamed Lemine Ould Mohamed Vadel" <leminef at mauritel.mr>
Cc: "AfNOG List" <afnog at afnog.org>
Sent: Monday, April 23, 2007 5:51 AM
Subject: Re: [afnog] Failover problem!


> Hallo Mohamed,
>
> 1. do you mean you have two links as well ?
>
> If yes, then you need to run iBGP (internal BGP) between two links for
> automatic take-over.
>
> If No, i.e you have only one link and two pix boxes.....i think the
> cheapest way is to have the two boxes configured equally, one to be put in
> production and the other one to be kept as a spare for replacement in case
> the one in production fails. Alternatively, you may be reguired to put
> both   pixs on line and configure two gateways  on clients(i.e one gateway
> from pix1 and another one from pix2 then, connections from 2nd interface
> on each pix should go into one access layer switch where all clients
> connect). Note..i think you should not do DHCP...just configure network
> parameters manually.Disadvantage of this approach is possibilty of
> increased latency.
>
> 2. for memory ....you just upgrade to eansure the same performance.
>
> try out,
>
> Fabian
>
> Hello,
>> I have two pix Cisco 515E and I would like their to configure in Failover
>> mode. The problem is that one of both is 64K of memory whereas other is
>> 128k
>> of memory. How could I cure this problem?
>> Regards
>>
>>
>> _______________________________________________
>> afnog mailing list
>> http://afnog.org/mailman/listinfo/afnog
>>
>>