[afnog] Loss of switchs configuration

[byaruhj@mtn.co.ug]

Oops ignore that. I mis-read "Switches" 


-----Original Message-----
From: afnog-bounces at afnog.org [mailto:afnog-bounces at afnog.org] On Behalf Of
byaruhj at mtn.co.ug
Sent: Thursday, September 08, 2005 4:15 PM
To: mtinka at africaonline.co.sz; kone at univ-ouaga.bf
Cc: afnog at afnog.org
Subject: Re: [afnog] Loss of switchs configuration

Also check the configuration register that you are working in for the routers
that lose these settings

JB 

-----Original Message-----
From: afnog-bounces at afnog.org [mailto:afnog-bounces at afnog.org] On Behalf Of
Mark Tinka
Sent: Thursday, September 08, 2005 3:58 PM
To: Kone
Cc: afnog at afnog.org
Subject: Re: [afnog] Loss of switchs configuration

On Thursday 08 September 2005 15:19, Kone wrote:
> Hello all,
> I have more then 15 switchs (Cisco 3524, 2950) on the
> network. I have configured vlans on all the switchs
> and trunk some ports. But sometimes, after the power
> down, the configuration is lost.

Do you lose the configuration on all 15 routers, or just 
a few?

When you boot up, do you lose the entire configuration, 
or just the VLAN specific settings?

> But after 
> modifaication I save the configuration #copy
> running-config startup-config

The 2950 NVRAM size is about 32K. How much of it are you 
using? You can show this when you type 'show run' and 
look at 'Current configuration : xxxx bytes' at the top 
of the output.

Mark.

> I use console port for the confuguration or Cisco
> Cluster Manager Systems CMS. The IOS of 2950 is
> 12.1(11)EA1.
> I need help please !
>
> ===============================
>
> Kone Bakenon K.
> Computer Center
> University of Ouagadougou
> 03 BP 7021 Ouagadougou 03
> Tel : +226 76 65 73 92
> Fax : +226 50 30 72 42
> Burkina Faso
> ===============================
>
> _______________________________________________
> afnog mailing list

_______________________________________________
afnog mailing list