[Date Prev][Date Next][Thread Prev][Thread Next][Date Index][Thread Index]
RE: Eth0 does not come up after kernel recompiling
Perhaps the module was not compiled into your new kernel.
If you still have a copy of your .config file, please check it to verify
whether your card was among the modules listed to be compiled as either
static or loadable.
Regards,
Mark Tinka - CCNA
Network Engineer
Africa Online Uganda
5th Floor, Commercial Plaza
7 Kampala Rd,
Tel: +256-41-258143
Fax: +256-41-258144
E-mail: mtinka at africaonline.co.ug
Web: www.africaonline.co.ug
-----Original Message-----
From: owner-afnog at afnog.org [mailto:owner-afnog at afnog.org]On Behalf Of
David Chima
Sent: Wednesday, April 16, 2003 12:45 PM
To: afnog at afnog.org
Subject: Eth0 does not come up after kernel recompiling
Hello
I have a problem. I have RedHat 7.2. I re-compiled my kernel as per the
instructions I
got from afnog. I updated my lilo.conf file to reflect the new kernel. The
machine booted
but eth0 did not come up. I checked /proc/modules and my 3Com card module
wasnt
there. I tried to use insmod to install it but it was in vain. It gives me
the fillowing error:
3c59x.o: unresolved symbol netdump_mode
What should I do?
Regards
David
-----
This is the afnog mailing list, managed by Majordomo 1.94.5
To send a message to this list, e-mail afnog at afnog.org
To send a request to majordomo, e-mail majordomo at afnog.org and put
your request in the body of the message (i.e use "help" for help)
This list is maintained by owner-afnog at afnog.org
-----
This is the afnog mailing list, managed by Majordomo 1.94.5
To send a message to this list, e-mail afnog at afnog.org
To send a request to majordomo, e-mail majordomo at afnog.org and put
your request in the body of the message (i.e use "help" for help)
This list is maintained by owner-afnog at afnog.org