RE:

["Mark Tinka" <mtinka at africaonline.co.ug>]

A signal 11 error normally says you have a hardware problem. It's either bad
physical memory, overheating CPU or jammed hard drive. Whatever the case,
you have a hardware problem. Please check your PC.

Regards,

Mark Tinka - CCNA
Network Engineer
Africa Online Uganda
5th Floor, Commercial Plaza
7 Kampala Rd,
Tel:   +256-41-258143
Fax:   +256-41-258144
E-mail: mtinka at africaonline.co.ug
Web:     www.africaonline.co.ug



-----Original Message-----
From: owner-afnog at afnog.org [mailto:owner-afnog at afnog.org]On Behalf Of
Joseph.Minja at britishcouncil.or.tz
Sent: Thursday, February 06, 2003 12:41 PM
To: afnog at afnog.org
Subject:


linux redhat 8.0 installaton abrots

"running anaconda the red hat installer..
install exited abnormally - received signal 11...
sending termination signals...
sending kill signals...
disabling swap...
unmounting file systems...
you may safely reboot"

very frustrating after getting new cds for rh8

can anybody advise please...

cheers



-----
This is the afnog mailing list, managed by Majordomo 1.94.5

To send a message to this list, e-mail afnog at afnog.org
To send a request to majordomo, e-mail majordomo at afnog.org and put
your request in the body of the message (i.e use "help" for help)

This list is maintained by owner-afnog at afnog.org



-----
This is the afnog mailing list, managed by Majordomo 1.94.5

To send a message to this list, e-mail afnog at afnog.org
To send a request to majordomo, e-mail majordomo at afnog.org and put
your request in the body of the message (i.e use "help" for help)

This list is maintained by owner-afnog at afnog.org