[afnog] Frame Relay Over E1

[byaruhj@mtn.co.ug]

Please look at my follow up e-mail, I configured my boxes and the
configuration looks good but the link doesn't come up.

Please advise

-----Original Message-----
From: Mark Tinka [mailto:mtinka at africaonline.co.zw] 
Sent: Wednesday, June 07, 2006 5:34 PM
To: James Byaruhanga
Cc: afnog at afnog.org
Subject: Re: [afnog] Frame Relay Over E1

On Wednesday 07 June 2006 16:04, byaruhj at mtn.co.ug wrote:

> What i am asking abt, is creating point to point links inside
> this serial interface generated by the channel group you have
> just created.
>
> I want to have multiple point to point links inside this one
> channel

Ah, that is fine... just create the frame relay sub-interfaces as 
outlined by Mwangi in his follow-up e-mail. Remember to have a 
similar DLCI on both sides. 

Assuming you are using an IOS later than 11.2, your LMI will be 
auto-detected from the frame relay network, either ANSI or 
Q.933a; default for this is Cisco (if you are using Cisco 
devices at both ends).

Don't forget that the bandwidth available to all sub-interfaces 
created under a single channel is limited to the number of 
DS-0's (nx64Kbps) you have assigned to said channel under the E1 
controller channel-group setting.

Cheers,

Mark.