[afnog] Ethernet Interface still UP even Cable is not plug into it
Bruno Agbessitse
mensah.agbessitse at gstelecom.net
Tue Jul 11 20:31:06 EAT 2006
Hi All,
I have a Cisco 1751 running IOS c1700-k9o3sy7-mz.124-1.bin.
When we removed the cable from the interface and check the interface it
status still shows up.
I can ping the interface but not the device connected to it.
Has someone seen this problem before?
Before I shutdown the interface
Goast#sh ip int b
Interface IP-Address OK? Method Status
Protocol
Ethernet1/0 xxx.xxx.xxx.xxx YES NVRAM up
up
Loopback0 xxx.xxx.xxx.xxx YES NVRAM up
up
Goast#sh run
After the interface was shutdown
Goast#sh ip int e1/0
Ethernet1/0 is administratively down, line protocol is down
Internet address is xxx.xxx.xxx.xxx/30
Broadcast address is 255.255.255.255
Address determined by non-volatile memory
MTU is 1500 bytes
Helper address is not set
Directed broadcast forwarding is disabled
Outgoing access list is not set
Inbound access list is not set
Proxy ARP is disabled
Local Proxy ARP is disabled
Security level is default
Split horizon is enabled
ICMP redirects are never sent
ICMP unreachables are never sent
ICMP mask replies are never sent
IP fast switching is enabled
IP fast switching on the same interface is disabled
IP Flow switching is enabled
IP CEF switching is disabled
IP Flow switching turbo vector
IP multicast fast switching is enabled
IP multicast distributed fast switching is disabled
IP route-cache flags are Fast, Flow cache, No CEF, Full Flow
Router Discovery is disabled
IP output packet accounting is disabled
IP access violation accounting is disabled
TCP/IP header compression is disabled
RTP/IP header compression is disabled
Policy routing is disabled
Network address translation is disabled
BGP Policy Mapping is disabled
Goast#
Bruno.
-------------- next part --------------
An HTML attachment was scrubbed...
URL: http://listserv2.cfi.co.ug/pipermail/afnog/attachments/20060711/60ef9d0f/attachment.html
More information about the afnog
mailing list