[afnog] MikroTik Router Wireless

[John Gitau]

> It still doesn't work, and as you can see the band defaults 
> to 2.4ghz-g.

Your card supports 802.11a/b only. So it definitely won't work on that
band. 
Try the following: (change the antenna to A from B like its been
suggested)

/interface wireless set wlan2 ssid="hotspot" frequency=2442
band=2.4ghz-b \
   antenna-mode=ant-a mode=ap-bridge disabled=no

If tha doesn't work, try shutting down wlan2, use the config above on
wlan1 and see if it transmits anything. If nothing gives, please test
with another client:-) or configure the two wireless cards on your
mikrotik to connect to each other just to confirm they can actually run.

**Gitau
Safaricom "The Better Option"
........................................................................
. 
"If the entire earth, land and water, were covered with computers, 
IPv6 would allow 7x10^23 IP addresses per square meter.  [...]  While it
was not the intention to give every molecule on the surface of the earth
its own IP address, we are not that far off."
	.. Tannenbaum, .Computer.Networks., 3rd Edition
........................................................................
.